Volkswagen Polo Service & Repair Manual: Wiring
- Vehicle Diagnosis, Testing and Information Systems
- Vehicle Diagnostic Tester, Connecting
- Vehicle Diagnostic Tester, Connecting, Golf MY 1998 through 2003
- Wiring Harness and Connector Repairs
- Vehicle Electrical System, General Repair Information
- Wiring Harness Repair Set
- Tool Descriptions
- Wiring Harnesses, Repairing
- Fiber-Optic Cables, Repairing
- Antenna Wires, Repairing
- Contact Housings and Connectors, Repairing
- Contact Housings, Releasing and Disassembling
- Contact Surface Cleaning Set -VAS6410
- Wiring Eyelets, Repairing
- Threaded Connections, Repairing
- Battery Terminal Clamp and Battery Terminal, Cleaning
- Protecting
- Heated Oxygen Sensor, Replacing
Cigarette Lighter Illumination Bulb -L28-, Removing and Installing
Note
On some vehicle equipment levels, socket illumination is via
Light Emitting Diode (LED) instead of a bulb. These LEDs are
integrated with th ...
Other materials:
Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
General Information
Perform a road test to determine if a vehicle pulls to one
side and if so, when and to which side. If the vehicle pulls to
one side. Refer to
→ Chapter „Corrective Action When Vehicle Pulls to One Side“.
If the vehicle ali ...
CAN Bus Wires, Repairing
Unshielded two-strand wiring -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
can be used as CAN bus wiring.
The color coding of CAN bus wires can be found in the
following table:
...
