Volkswagen Polo Service & Repair Manual: Wiring Harnesses, Repairing
- Airbag and Belt Tensioner Wire Repair Information
- CAN Bus Wires, Repairing
- Antenna Wires, Replacing
- Wires with Cross Section up to 0.35 mm 2, Repairing
- Wire Break with Single Repair Point
- Wire Break with Dual Repair Point
Crimping Pliers - .35-2.5mm -VAS1978/1A
The Crimping Pliers - .35-2.5mm -VAS1978/1A- or the Wiring
Harness Repair - Crimping Plier - Base Tool -VAS1978/1-2-
together with the Wiring Harness Repair - Crimpin ...
Airbag and Belt Tensioner Wire Repair Information
Note
Observe general notes for repairs on the vehicle electrical
system. Refer to
→ Chapter „Vehicle Electrical System, General Repair
...
Other materials:
4-Pin Heated Oxygen Sensor (HO2S), Removing and Installing
Note
Do not repair the heated oxygen sensor wires. Repairing may
result in malfunctions.
Use the faulty sensor as a guide for installing all of the
accompanying attachments, cable ties or marking bands.
...
Trailer Socket
Connect the trailer socket to the vehicle electrical system
of the vehicle pulling the trailer according to the manufacturer
instructions.
Refer to the applicable wiring diagrams or manufacturer
installation instructions when installing ...
Test Requirements
Note
The A/C system is functioning correctly when the air flowing
from the instrument panel vents has a temperature of 70C
or lower.
Setting on Climatronic “LO”.
Setting on A/C system ...
