Volkswagen Polo Owners Manual: Starting the engine, changing gear and parking
- Starting and stopping the engine
- Changing gear
- Introduction
- Warning and indicator lamp
- Pedals
- Manual gearbox: selecting a gear
- Automatic gearbox: selecting a gear
- Changing gear using Tiptronic
- Driving with an automatic gearbox
- Fault in the function of the automatic gearbox
- Gear-change indicator
- Braking, stopping and parking
- Introduction
- Warning and indicator lamps
- Handbrake
- Parking
- Information on the brakes
- Brake support systems
- Switching the TCS on and off
- Brake fluid
- Driving with respect for the environment
- Steering
Socket in the vehicle
Fig. 106 Front centre console: 12-volt
socket
First read and observe the introductory information
and safety warnings
Maximum power rating
Electrical socket
Maximum p ...
Other materials:
Run-Flat Tire PAX
WARNING
Run-flat tires must be replaced after they have gone
flat.
Pay close attention to the installation
instructions. Refer to
→ Chapter „Tir ...
Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator
Valve -N280-, Externally Regulated A/C Compressor
Specified Values
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „P ...
Threaded Connections, Repairing
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Note
Do not use rust remover, contact spray or grease because the
lack of friction will cause the torque to be ...
