Volkswagen Polo Owners Manual: Warning and indicator lamp

Volkswagen Polo Owners Manual / Starting the engine, changing gear and parking / Changing gear / Warning and indicator lamp

First read and observe the introductory information and safety warnings

Lit up	Possible cause	Solution
	Dual clutch gearbox DSG^® overheated.	Do not drive on! Move the selector lever to position P and leave the gearbox to cool down. If the warning lamp does not go out, do not continue to drive. Seek expert assistance. Failure to do so can cause considerable damage to the gearbox .
	Brake pedal not depressed.	To select a position, press the brake pedal .

Flashes	Possible cause	Solution
	The lock button in the selector lever is not engaged. The vehicle cannot drive off.	Engage the selector lever lock .
	Fault in automatic gearbox. flashes alternately with selector lever display e.g. D.	Drive to the nearest qualified workshop immediately at a low engine speed to have the system checked.

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

Failure to observe illuminated warning lamps and text messages can lead to your vehicle breaking down in traffic, and can cause accident and serious injury.

Never ignore any illuminated warning lamps or text messages.

Stop the vehicle as soon as possible and when safe to do so.

If the vehicle is stationary or has to be parked for repairs, always park the vehicle at a safe distance from the road, switch on the hazard warning lights, switch off the engine and take other precautionary measures in order to warn the traffic behind you.

NOTICE

Failure to observe illuminated indicator lamps and text messages can lead to your vehicle being damaged.

Introduction

This chapter contains information on the following subjects: → Warning and indicator lamp → Pedals → Manual gearbox: selecting a gear → Automatic gea ...

Pedals

Fig. 108 Pedals in vehicles with a manual gearbox: ① accelerator, ② brake pedal, ③ clutch pedal Fig. 109 Pedals in vehicles with an automatic gearbox: ① accelerator, ② brake pedal Fi ...

Other materials:

Rear towing eye
Fig. 194 In the rear bumper on the right-hand side: removal of the covers for the towing eye Fig. 195 In the rear bumper: removal of the covers for the towing eye First read and observe the introductory information and safety warnings There is a fixed towing eye located underneath the rea ...

Parking Aid Sensor, Painting
The following parameters must be met when painting to avoid malfunctions in the parking aid sensor (parking aid system): New Part, Painting Maximum coat thickness 125 µm; the coat thickness must always be measured ...

Reinforced Shock Absorbers and Coil Springs
Reinforced shock absorbers and coil springs on the vehicle rear axle reduce pitching motions between the vehicle and the trailer. If not already installed in the factory, these shock absorbers and springs can often be retrofitted at authorized Volk ...