Driving in a fuel-efficient manner
IntroductionWires with Cross Section up to 0.35 mm 2,
Repairing
Special tools and workshop equipment
required
Crimping Pliers - .35-2.5mm -VAS1978/1A-
Wiring Harness Repair - Crimping Head - .35-2.5mm
-VAS1978/1-1-
When repairing wires with a cross- ...
Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Refrigerant in A/C Service station Container, Filling
Caution
If it is suspected that chemicals were added to the
refrigerant circuit to seal leaks, do not connect the
A/C service station and do not extract the refrigerant.
...