Volkswagen Polo Owners Manual: Changing a wheel

Wheel bolt caps

Fig. 165 Removing the wheel bolt caps First read and observe the introductory information and safety warnings Take the wire hook from the vehicle toolkit . Insert the hook through th ...

Introduction

This chapter contains information on the following subjects:  → Preparations for changing a wheel  → Wheel bolts  → Lifting the vehicle with the jack  → Changing a w ...

Other materials:

Test Requirements
Radiator and condenser are clean (clean if necessary). The ribbed belt for the A/C compressor and alternator tensioned correctly. All air ducts, covers and seals are OK and installed correctly. ...

Wire Break with Dual Repair Point
Repair point with intermediate wire section –  Free up wire intended for repair at two points (approximately 20 cm to both sides of respective repair points). –  If required, remove wiring harness wra ...

Single Wire Seals, Installing
  Note Single wire seals prevent the penetration of water and dirt into the contact housing. They are installed, for example, in the engine compartment and must be reinstalled after a repair. Single wire seal is crimpe ...