Volkswagen Polo Owners Manual: Wheel bolt caps
Fig. 165 Removing the wheel bolt caps
First read and observe the introductory
information and safety warnings
- Take the wire hook from the vehicle toolkit .
- Insert the hook through the opening in the cap and pull off in the direction of the arrow.
The caps protect the wheel bolts and must be replaced after changing the tyre.
The anti-theft wheel bolt has a separate cap. It only fits onto the anti-theft wheel bolts and not onto conventional wheel bolts.
Wheel cover
Fig. 163 Removing press-on wheel
covers
Fig. 164 Removing bolted-on wheel
covers
First read and observe the introductory
information and safety warnings
Removing and fitting press-on wheel ...
Changing a wheel
...
Other materials:
Flushing Circuit Block Diagrams
Note
The arrows in the following illustrations show the direction
of refrigerant flow while flushing. During flushing, refrigerant
flows in the opposite direction than during A/C system
operation, therefore the high pressure side of A/C se ...
Siemens Wheel Electronics Tire Pressure Monitoring Sensor, Removing and
Installing
WARNING
If tire sealant was used, then the wheel electronics
on that particular wheel must be replaced.
The Siemens wheel electronics does not have a
microencapsulated ...
Tire Sidewall Swelling
A swelling in the flank of the tire indicates that the
substructure of the carcass has been damaged.
Typical causes for such damage include, for example, driving
over curbs at a sharp angle.
...
