Air recirculation mode
Filling the tankTire Pressure Sensor and Metal Valve, Removing and Installing
Special tools and workshop equipment
required
Torque Wrench 1410 -VAG1410- and Torque Wrench 1331 5-50Nm
-VAG1331-
–
Place metal valve with rubber seal through rim from inside.
...
Adhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
Dry sand the cataphoretic primer on the roof adhesive surface
-item 6-
→ Item down to the bare metal using P180 sandpaper.
–
Dry sand the roof pillar adhesive surface
...
Ignition lock
Fig. 107 Positions of the vehicle key in
the ignition lock
First read and observe the introductory information
and safety warnings The steering lock can be activated when
there is no vehicle key in the ignition lock.
Vehicle key positions
Ignition switched off. The vehicle key ca ...