Checklist
IntroductionValve, Removing and Installing, Metal Valve
Special tools and workshop equipment
required
Torque Wrench -VAG1410-
Perform the Following:
Removing
–
Remove the Tire Pressure Monitoring Sensor. Refer to
...
Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Searching for Refrigerant Circuit Leaks with Compressed Air or Nitrogen
Note
This repair manual describes different methods for detecting
leaks in the refrigerant circuit. These methods have been tested
and result in success when used correctly.
If when searching for compressed air / Nit ...