Volkswagen Polo Service & Repair Manual: Tire Pressure Monitoring Sensor, Removing and Installing

Overview - Tire Pressure Monitoring Sensor without Valve

1 -  Valve Cap 2 -  Nut Individual component of -item 7- → Item Tightening specification. Refer to ...

Tire Pressure Monitoring Sensor with Valve, Removing and Installing

Removing     –  Remove the union nut -1-. –  Remove Tire Pressure Moni ...

Other materials:

Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...

Tyre pressure
Fig. 146 On the inside of the tank flap: tyre inflation pressure label First read and observe the introductory information and safety warningsThe correct tyre pressure for factory-fitted tyres is shown on a sticker and applies to all-season, summer and winter tyres. The sticker is located ...

Introduction
This chapter contains information on the following subjects:  → Socket in the vehicle Electrical equipment can be connected to the socket in the vehicle. The devices connected must be in good condition and fault-free. Additional information and warnings: Cigarette lighter Acce ...