Plastic Primer
Two-Part HS Vario FillerTaper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
Indicator lamps
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Engine management system fault (Electronic Power Control).
The engine should be checked by a qualified workshop
as s ...
Wheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...