Flat Spots, Correcting
Flat SpotsWheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Wires with Cross Section up to 0.35 mm 2,
Repairing
Special tools and workshop equipment
required
Crimping Pliers - .35-2.5mm -VAS1978/1A-
Wiring Harness Repair - Crimping Head - .35-2.5mm
-VAS1978/1-1-
When repairing wires with a cross- ...
Searching for Refrigerant Circuit Leaks with Compressed Air or Nitrogen
Note
This repair manual describes different methods for detecting
leaks in the refrigerant circuit. These methods have been tested
and result in success when used correctly.
If when searching for compressed air / Nit ...