Volkswagen Polo Service & Repair Manual: Checking with Expansion Valve and Receiver/Dryer, without Regulated A/C Compressor

Checking with Expansion Valve and Receiver/Dryer, with Internally Regulated A/C Compressor

  Note Connecting service station. Refer to → Chapter „Connecting Service Station“. Observe test requirements ...

Test Requirements

Radiator and condenser are clean (clean if necessary). The ribbed belt for the A/C compressor and alternator tensioned correctly. ...

Other materials:

How to start the engine using jump leads
Fig. 191 How to connect the jump leads when starting vehicles without start/stop system: discharged battery Ⓐ and battery providing assistance Ⓑ Fig. 192 How to connect the jump leads when starting vehicles with start/stop system: discharged battery Ⓐ and battery providing assistance ...

Introduction
This chapter contains information on the following subjects:  → Stowage  → Contents Observe any country-specific legislation when securing your vehicle in the event of a breakdown. Additional information and warnings: Preparation for working in the engine compartment ...

Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...