Volkswagen Polo Service & Repair Manual: Contact Surface Cleaning Set -VAS6410
- Wiring Eyelets, Repairing
- Threaded Connections, Repairing
- Battery Terminal Clamp and Battery Terminal, Cleaning
- Protecting
Special Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer ...
Wiring Eyelets, Repairing
Special tools and workshop equipment
required
Torque Wrench 1331 5-50Nm -VAG1331-
Note
Do not use r ...
Other materials:
Changing bulbs in the side turn signals
Fig. 188 Removing the side turn
signal bulb
Fig. 189 Side turn signal:
changing the bulb
First read and observe the introductory
information and safety warnings
Depending on the vehicle, the side turn signal may be located in the front
wing or in the exterior mirror .
Please contact a ...
Start/stop system
Fig. 119 In the upper part of the centre
console: button for the start/stop system
First read and observe the introductory information
and safety warnings If the start/stop system is activated, the
engine will be switched off automatically when the vehicle is stationary. When required,
t ...
Introduction
This chapter contains information on the following subjects:
→ Stowage
→ Contents
Observe any country-specific legislation when securing your vehicle in the
event of a breakdown.
Additional information and warnings:
Preparation for working in the engine compartment
...
