First read and observe the introductory information
and safety warnings
One-touch opening and closing
One-touch opening and closing makes it possible to fully open and close the windows. The individual buttons do not have to be held down to do this.
For one-touch closing: pull the button for the appropriate window up briefly into the second position.
For one-touch opening: press the button for the appropriate window down briefly into the second position.
Stopping the one-touch function: press or pull the button for the appropriate window again.
Restoring one-touch opening and closing
One-touch opening and closing is deactivated if the vehicle battery has been disconnected or discharged while the windows were not fully closed. The function will have to be reset.
The one-touch function can be restored for individual windows or for several windows at the same time.
Convenience opening or closing
The windows can be opened and closed from outside the vehicle using the vehicle key:
During convenience closing, first the windows and then the electric panorama sliding/tilting glass roof.

WARNING
One-touch opening and closing and the roll-back function will not work if there is a fault in the electric windows. Go to a qualified workshop.
Opening or closing the windows electrically
Roll-back function for the electric windowsService interval display
First read and observe the introductory
information and safety warnings
The service display is shown on the instrument cluster or .
Service schedules at Volkswagen are divided into two categories, oil change
service and inspections. The service interval display provides information on
the n ...
Loading the trailer
First read and observe the introductory information
and safety warnings
Trailer weight and drawbar load
The trailer weight is the weight that the vehicle can pull . The drawbar load
is the weight that the towing bracket exerts on the ball coupling vertically from
above .
The figures for tr ...
7-Pin« Trailer Socket
If more electrical consumers need to be connected than the
»7-pin« socket allows, a second
»7-pin« socket must be installed.
Pin assignment must conform to DIN ISO 1724:
1 - Left turn signal
2 - Tail ...