VW Polo manuals

Volkswagen Polo Owners Manual: Introduction

This chapter contains information on the following subjects:

 → Contents of the breakdown set
 → Preparation
 → Sealing and inflating tyres
 → Test after driving for 10 minutes

You can use the breakdown set (tyre mobility set) to safely seal any tyre damage caused by foreign bodies or punctures (up to 4 mm in diameter). Do not remove foreign objects (e.g. screws or nails) from the tyre!

Once the sealant has been added to the tyre, the tyre pressure must be checked again after approximately 10 minutes of driving.

Seek expert assistance if more than one vehicle tyre is damaged. The breakdown set is only designed for filling one tyre.

Only use the breakdown set if the car is parked in a safe place, you are familiar with the required actions and safety procedures, and you have access to the correct breakdown set. Seek expert assistance if this is not the case.

The tyre sealant must not be used:

Additional information and warnings:

WARNING

Using the breakdown set can be dangerous, especially if the tyres are inflated at the roadside. Please note the following steps in order to reduce the risk of serious injuries:

WARNING

Tyres that have been filled with sealant will not handle in the same way as a standard tyre.

Dispose of used or out-of-date sealant in accordance with legal requirements.

You can get a new tyre filler bottle from a Volkswagen dealership.

Observe the separate instructions from the manufacturer of the breakdown set.

Breakdown set
...

Contents of the breakdown set
Fig. 171 The breakdown set First read and observe the introductory information and safety warnings The breakdown set is located underneath the floor covering in the luggage compartment. It incl ...

Other materials:

Various securing systems
Fig. 62 On the rear seats: figure Ⓐ illustrates the main securing points for the child restraint system on the lower retaining rings and top tether. Figure Ⓑ shows how to secure a child restraint system using the vehicle's seat belt First read and observe the introductory information a ...

Diagonal Washouts
Diagonal wear spots on tires Diagonal wear spots run at an angle of approximately 45° with respect to the plane of circumference. They usually occur once, but may also occur several times along the tire circumference. ...

Main menu
First read and observe the introductory information and safety warnings Menu Function See MFD Information and settings for the multifunction display (MFD). Audio Station display in radio mode. Trac ...

© 2016-2026 Copyright www.vwpolo.net