Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
Refrigerant, Keeping Records
Note
The laws and regulations listed below are applicable in
Germany. Different or additional laws and regulations may apply
in other countries.
Addresses in other countries can be obtained from the
relevant au ...
Introduction
This chapter contains information on the following subjects:
→ Preparations for changing a wheel
→ Wheel bolts
→ Lifting the vehicle with the jack
→ Changing a wheel
→ After changing a wheel
Some models are delivered without a factory-fitted jack or ...