Volkswagen Polo Service & Repair Manual: Charging Systems not Requiring a Permit

Volkswagen Polo Service & Repair Manual / Refrrigerant R134a Servicing / Refrigerant Circuit General Information / A/C Service and Recycling Units / Charging Systems not Requiring a Permit

At this time, A/C service units for extracting, cleaning and filling refrigerant for motor vehicle A/C systems are available from various manufacturers.

Charging systems not requiring a permit are ones used for transferring compressed gases to mobile compressed-gas vessels for internal use only.

Note:

Some A/C service units are charging systems not requiring a permit. When working with such equipment, the refrigerant is not transferred to mobile compressed-gas vessels, but rather into a permanently installed charging cylinder with visible level gauge and float switch.

Recommendation:

It is advisable to use a portable cylinder with visible level gauge and pressure relief valve for surplus refrigerant for internal use.

Observe the different technical regulations for handling and filling compressed gases in other compressed-gas vessels (for example RGS 400, TRGS 402, TRGS 407, TRGS 510, TRBS 3145 / TRGS 725).

Extraction System Group Classifications

At this time, A/C service units for extracting, cleaning and filling refrigerant for motor vehicle A/C systems are available from various manufacturers. ...

Refrigerant Circuit Repair Information

WARNING When performing work on refrigerant circuit, observe all generally applicable safety precautions and pressure ...

Other materials:

Preserving Wax
Definition: Preserving Wax -AKR 321 M15 4- Preserving Wax -AKR 321 M16 10- Edition 04/2009 Product Description Preserving Wax -AKR 321 M15 4- and Prese ...

Tires, Dismounting, Wheels without and with Tire Pressure Monitoring System
If equipped check the tire pressure monitoring sensor with the vehicle diagnostic tester and if necessary replace. Note When cleaning disc wheel (rim), the tire pressure monitoring sensor (if equipped) must not come into c ...

Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...