Synchronising the vehicle key
IntroductionWires with Cross Section up to 0.35 mm 2,
Repairing
Special tools and workshop equipment
required
Crimping Pliers - .35-2.5mm -VAS1978/1A-
Wiring Harness Repair - Crimping Head - .35-2.5mm
-VAS1978/1-1-
When repairing wires with a cross- ...
Introduction
This chapter contains information on the following subjects:
→ Seat heating
Additional information and warnings:
Adjusting the seat position
Seat belts
Airbag system
Child seats (accessories)
Exterior mirrors
Luggage compartment
WARNING
Incorrec ...
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...