Volkswagen Polo Service & Repair Manual: Battery, Charging with Battery Charger -VAS5095A
| Special tools and workshop equipment
required |
| Battery Charger -VAS5095A- |
WARNING
| Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ Chapter „Warnings and Safety Precautions“. |
|
Caution
| While charging, always set the battery type to 2.4
V/C (Volts/Battery Cell)! This applies to all batteries. |
|
Note
| The battery temperature must be at least 10 °C (50 °F). |
WARNING
| Batteries that have a light yellow visual indicator
do not have to be tested or charged. Jump starting must
not be used! |
| There is a risk of explosion during testing,
charging or jump starting. |
| These batteries must be replaced. |
|
| – |
Turn off the ignition and all electrical consumers. |
| – |
Check the battery type setting on the battery type selector.
Refer to
→ Chapter „Battery Charger -VAS5095A- Device Description“.
It must be set to 2.4V/C (Volts/Cell). |
| – |
Clamp the red charging clamp “+” of the charger to the
positive battery terminal. |
Note
| In the case of vehicles with a start/stop function and an
installed Battery Monitoring Control Module -J367-, the black
charging clamp “-” must be connected to the body ground. The
start/stop system will malfunction if it is connected to the
negative terminal on the battery. |
| – |
Connect the black charging clamp “-” of the charger to the
negative battery terminal. |
| – |
Switch on the battery charger. Refer to
→ Chapter „Battery Charger -VAS5095A- Device Description“. |
| Charge current displays. Refer to
→ Fig. „“Battery Charger -VAS5095A- ”“-2-
and -3- light up yellow. When only
the yellow LED -3- is lit, the
battery is partially charged (approximately 90%). |
| If the green LED. Refer to
→ Fig. „“Battery Charger -VAS5095A- ”“-4-
is also lit, the charger has switched to the charge sustain
function. The battery is charged. |
| – |
Switch off the charger. Refer to
→ Chapter „Battery Charger -VAS5095A- Device Description“. |
| – |
Remove the charger clamps from the battery terminals. |
|
|
|
WARNING
Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ Chapter „Warnings and ...
WARNING
Risk of injury. Follow all Warnings and Safety
Precautions. Refer to
→ Chapter „Warnings and ...
Other materials:
Information stored in the control units
First read and observe the introductory information
and safety warningsYour vehicle is factory fitted with electronic control
units which are responsible for engine and gearbox management. The control units
also monitor the function of the exhaust system and the airbags.
These electronic con ...
Checklist
Please note the following for the cleaning and maintenance of the
seat covers :
Before getting into the vehicle, close all
Velcro fasteners that could touch the cloth seat covers and fabric trims. Open
Velcro fasteners can cause damage to cloth seat covers and fabric trims.
Avoid ...
Securing child seats with a seat belt
First read and observe the introductory information
and safety warnings
It is permissible to fasten child seats with universal written
on the orange label to the seats using the seat belt, but only on the seats marked
in the table with a u.
Weight class
Front passe ...
© 2016-2026 Copyright www.vwpolo.net
