Volkswagen Polo Owners Manual: Service position for the front windscreen wipers
Fig. 74 Wiper blades in service position
First read and observe the introductory information
and safety warnings
The windscreen wiper arms can be lifted off the windscreen when in the service position . Carry out the following steps to move the windscreen wipers to the service position:
- The bonnet must be closed .
- Switch the ignition on and then off again.
- Briefly press down the windscreen wiper lever .
Place the windscreen wiper arms back onto the windscreen before driving away. Briefly press the windscreen wiper lever down to bring the windscreen wiper arms back to the original position.
Lifting the windscreen wiper blades
- Move the wiper arms to the service position before lifting .
- When lifting a wiper arm hold it only by the wiper blade mounting.
NOTICE
- In order to prevent damage to the bonnet and the windscreen wiper arms, the windscreen wiper arms should only be lifted when in the service position.
- Always return the windscreen wiper arms to the windscreen before starting your journey.
Windscreen wiper functions
First read and observe the introductory information
and safety warnings
Windscreen wiper response in various
situations:
When the vehicle is stationary.
W ...
Rain/light sensor
Fig. 75 Windscreen wiper lever: setting
the rain/light sensor Ⓐ
Fig. 76 Sensitive surface of the rain/light
sensor
First read and observe the introductory information
and safety warnings
...
Other materials:
Disintegrated Tread
Tires with Torn-Out Tread
Such damage usually develops over a longer period of time.
If an already damaged tire is exposed to high stress, the
centrifugal force at higher speeds can tear components off the
tire.
Il ...
A/C Compressor Regulator Valve -N280
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
Refer to
→ Rep. Gr.87.
...
General Information
In order to be able to force moisture and other contaminants
out of refrigerant circuit, compressed air and nitrogen (to
force moisture out of refrigerant circuit) are to be used.
For the most part, blowing through the refrigerant circui ...