Volkswagen Polo Service & Repair Manual: Tire Service Life, Influences
| The following factors influence the service life of a tire
in varying degrees. |
| Exterior temperature/climate |
| Dynamic toe and camber values |
| Tire Operating Conditions |
| Changes to the Suspension: |
| If a “lowering-kit” and /or light alloy wheels from
accessories which have not been approved by the vehicle
manufacturer are used, wheel alignments which deviate from the
alignment specified in design may occur during travel. |
| Even if the adjustment of the axle geometry measured on a
standing vehicle is correct, changes in the body height and
positions of the wheels during travel can lead to changes to the
paths of travel of the wheel suspension. |
| For this reason, uneven wear is pre-programmed. |
|
|
|
Heel-and-toe wear is step-like wear of individual tread
blocks, due to which an increased rolling noise can develop. The
heel-and-toe wear is caused by the uneven dis ...
Other materials:
Flushing Circuit Block Diagrams
Note
The arrows in the following illustrations show the direction
of refrigerant flow while flushing. During flushing, refrigerant
flows in the opposite direction than during A/C system
operation, therefore the high pressure side of A/C se ...
Release Tool Set -VAS1978/35
The Release Tool Set -VAS1978/35- is used to release the
various primary and secondary locking mechanisms on VW-group
vehicles. The set consists of 26 different tools which can be
used to professionally release or assemble e.g. round connector
systems, f ...
Ignition lock
Fig. 107 Positions of the vehicle key in
the ignition lock
First read and observe the introductory information
and safety warnings The steering lock can be activated when
there is no vehicle key in the ignition lock.
Vehicle key positions
Ignition switched off. The vehicle key ca ...
© 2016-2026 Copyright www.vwpolo.net
Tire Wear
Heel and Toe Wear