Volkswagen Polo Service & Repair Manual: Run-Flat Tire PAX
WARNING
| Run-flat tires must be replaced after they have gone
flat. |
| Pay close attention to the installation
instructions. Refer to
→ Chapter „Tires, Mounting“. |
|
| – |
The wheel must be inspected before mounting, as with
conventional wheel and tire systems. |
| – |
Check the rim for damage after a flat tire (true running,
axial run-out, other damage) because the rim could be damaged in
an emergency by driving through a pothole. Refer to
→ Chapter „Wheel, Mounting“. |
| – |
A damaged rim should be replaced. |
|
|
|
Caution
Using run-flat tires on vehicles is permitted only
if the run-flat tire is supplied with the vehicle either
...
Storage Room
Tire storage must be:
Dark,
Dry,
Cool and
...
Other materials:
Diagonal Washouts
Diagonal wear spots on tires
Diagonal wear spots run at an angle of approximately 45°
with respect to the plane of circumference.
They usually occur once, but may also occur several times
along the tire circumference.
...
Introduction
This chapter contains information on the following subjects:
→ Socket in the vehicle
Electrical equipment can be connected to the socket in the vehicle.
The devices connected must be in good condition and fault-free.
Additional information and warnings:
Cigarette lighter
Acce ...
Pneumatic Brush Grinder Set -VAS6446
Definition:
Pneumatic Brush Grinder Set -VAS6446-
Product Description:
The Pneumatic Brush Grinder Set -VAS6446- serves to prepare
the surface.
For example: removes underbody ...
© 2016-2026 Copyright www.vwpolo.net
Run-Flat Tire, Retrofitting/Conditions for use of Run-Flat Tires
Tires, Storing