Volkswagen Polo Owners Manual: Radio reception and aerials

Volkswagen Polo Owners Manual / Vehicle care and maintenance / Consumer information / Radio reception and aerials

First read and observe the introductory information and safety warnings

For factory-fitted radio or navigation systems, the aerial for radio reception can be installed in various locations in the vehicle:

On the inside of the rear window, together with the rear window heating.

On the inside of the rear side windows.

On the inside of the windscreen.

On the roof of the vehicle.

Aerials on the interior of the windows can be identified by thin wires.

NOTICE

Aerials located on the inside of the windows can be damaged by corrosive or acidic detergents, any other chemicals or if hard objects chafe against the window. Never apply stickers over the window aerials and never clean the aerials with corrosive or acidic detergents or any other chemicals.

Interference of AM radio reception could occur if electrical devices are used in the vicinity of the aerials in the windows.

Using the vehicle in other countries and continents

First read and observe the introductory information and safety warningsThe vehicle has been manufactured specifically for a particular country and complies with the registration regulations that a ...

Volkswagen repair information

First read and observe the introductory information and safety warningsVolkswagen Service information and official Volkswagen repair information can be purchased from the following addresses: Cu ...

Other materials:

Overview - Tire Pressure Monitoring Sensor without Valve
1 - Valve Cap 2 - Nut Individual component of -item 7- → Item Tightening specification. Refer to → Anchor. Always replace if removed 3 - W ...

Towing Recognition Control Module -J345
General Information The Towing Recognition Control Module -J345- recognizes “trailer mode” when there is a power decrease of at least 5 W → Note and transmits this information to various control modules via the CAN data bu ...

6-Pin Universal Oxygen Sensor, Removing and Installing
Note Use the faulty sensor as a guide for installing all of the accompanying attachments, cable ties or marking bands. Do not crimp or cut the wires otherwise the functionality of the heated oxygen sensor (HO2S) will ...