Volkswagen Polo Owners Manual: Notes on tow-starting
First read and observe the introductory
information and safety warnings
Vehicles should not be tow-started wherever possible. Use jump leads to start the engine instead .
For technical reasons, the following vehicles cannot be tow-started:
- Vehicles with an automatic gearbox.
- If the vehicle battery has discharged, the engine control units will not function properly.
However, if the vehicle still has to be tow-started (manual gearbox):
- Engage second or third gear.
- Keep the clutch pressed down.
- Switch on the ignition and the hazard warning lights.
- Once both vehicles are in motion, release the clutch.
- As soon as the engine starts, press the clutch and put the gear into neutral. This helps to prevent driving into the towing vehicle.
NOTICE
Introduction
This chapter contains information on the following subjects:
→ Notes on tow-starting
→ Notes on towing
→ Fitting the front towing eye
→ Rear towing eye
â ...
Notes on towing
First read and observe the introductory
information and safety warnings
Tow rope or tow bar
It is easier and safer to tow a vehicle with a tow bar. Only use a tow rope
if you do not have a tow b ...
Other materials:
CAN Bus Wires, Repairing
Unshielded two-strand wiring -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
can be used as CAN bus wiring.
The color coding of CAN bus wires can be found in the
following table:
...
Releasing and Disassembly Contact Housings, General Information
Note
Observe general notes for repairs on the vehicle electrical
system. Refer to
→ Chapter „Vehicle Electrical System, General Repair
Information“.
Always use the release tools intended for the ...
Factory Paint Paint Structure
Structure of a Solid-Color Paint System, Conventional
Approximately 80-120 µm thick
1 -
Steel Panel
2 -
Zinc Phosphate Coating
3 -
Electr ...
