First read and observe the introductory information
and safety warnings
| Lit up | Possible cause | Solution |
|---|---|---|
|
The start/stop system is not available. Automatic engine switch-off is active. | Take your foot off the brake to start the engine again . |
|
Automatic engine switch-off is not possible.
OR: automatic engine start is not possible. OR: the engine was started automatically. |
Check whether all technical requirements have been fulfilled. If not, remedy any shortfalls . |
|
The engine is starting. | – |
Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

WARNING

NOTICE
Introduction
Start/stop systemAdhesive Surface Pretreatment when Replacing Laser-Soldered Roofs
Dry sand the cataphoretic primer on the roof adhesive surface
-item 6-
→ Item down to the bare metal using P180 sandpaper.
–
Dry sand the roof pillar adhesive surface
...
Checklist
Please note the following for the cleaning and maintenance of the
seat covers :
Before getting into the vehicle, close all
Velcro fasteners that could touch the cloth seat covers and fabric trims. Open
Velcro fasteners can cause damage to cloth seat covers and fabric trims.
Avoid ...
Changing bulbs in the front headlights (halogen H4)
Fig. 178 Rear view of the
right-hand H4 headlight with plastic covers: ① dipped beam and main beam, ② turn
signal and ③ side light
Fig. 179 Rear view of the
right-hand H4 headlight with rubber cover: ① dipped beam and main beam, ② turn
signal and ③ side light
First read and o ...