Volkswagen Polo Service & Repair Manual: Contact Housings, Releasing and Disassembling
- Releasing and Disassembly Contact Housings, General Information
- Secondary Lock
- Primary Lock
- Round Connector Systems
- Flat Connector Systems
- Special Connector Systems
Contact Housings, Repairing Wire Terminals
Note
For technical reasons, the contact housing for the wire
terminals can be supplied only with the contacts p ...
Releasing and Disassembly Contact Housings, General Information
Note
Observe general notes for repairs on the vehicle electrical
system. Refer to
→ Chapter „Vehicle Electrical System, General Repa ...
Other materials:
Operating ParkPilot
Fig. 120 In the rear bumper: ParkPilot
ultrasound sensors
First read and observe the introductory information
and safety warnings The ParkPilot uses ultraound sensors to
determine the distance between the rear bumper and an obstacle. There are 4 ultrasound
sensors in the rear bumper ...
Wheel, Balancing on Stationary Balancing Machine
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
AGM Battery, Checking
Perform Battery Checks in the Following Sequence:
1.
Visual inspection. Refer to
→ Chapter „Visual Inspection“.
2.
Check the battery using the Battery Tester -VAS6161-. Refer
to
...
