Volkswagen Polo Owners Manual: Changing a bulb
- Introduction
- Indicator lamp
- Information on changing bulbs
- Checklist
- Removing and installing the headlights
- Changing bulbs in the front headlights (halogen H4)
- Changing bulbs in the front headlights (halogen H7)
- Changing bulbs in the front headlights (Xenon)
- Changing bulbs in the front bumper
- Changing the bulbs in the tail light cluster
- Changing the bulb in the number plate light
- Changing bulbs in the side turn signals
Changing a blown fuse
Fig. 174 A blown fuse
Fig. 175 Removing or fitting a
fuse using the plastic pliers ①
First read and observe the introductory
information and safety warnings
Preparation
Switch off the ...
Introduction
This chapter contains information on the following subjects:
→ Indicator lamp
→ Information on changing bulbs
→ Removing and installing the headlights
→ Changing ...
Other materials:
Refrigerant Circuit Connections with Valve for Switches
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
Refer to
→ Rep. Gr.87.
...
Tire Pressure Monitoring Sensor with Valve, Removing and Installing
Removing
–
Remove the union nut -1-.
–
Remove Tire Pressure Monitoring Sensor-2-
from rim well.
Installing
...
Wire Break with Dual Repair Point
Repair point with intermediate wire section
–
Free up wire intended for repair at two points
(approximately 20 cm to both sides of respective repair points).
–
If required, remove wiring harness wra ...
