Volkswagen Polo Owners Manual: Indicator lamp

Volkswagen Polo Owners Manual / Changing a bulb / Indicator lamp

First read and observe the introductory information and safety warnings

Lit up	Possible cause	Solution
	There is a defective bulb in the vehicle's exterior lighting.	Change the defective bulb.

Several warning and indicator lamps will light up briefly as a functional check when the ignition is switched on. They will switch off after a few seconds.

Monitoring of the light bulbs on the trailer

For vehicles with a factory-fitted towing bracket, the vehicle will also monitor certain bulbs on a trailer which has been connected properly via the trailer socket:

If a turn signal in the trailer fails, the indicator lamp ( or ) in the instrument cluster will flash twice as fast .

Failure of all turn signals on one side.

Failure of the tail light on one side in some models, failure of the licence plate light.

Failure of both brake lights.

WARNING

Failure to observe illuminated warning lamps and text messages can lead to your vehicle breaking down in traffic, and can cause accident and serious injury.

Never ignore any illuminated warning lamps or text messages.

Stop the vehicle as soon as possible and when safe to do so.

NOTICE

Failure to observe illuminated indicator lamps and text messages can lead to your vehicle being damaged.

Introduction

This chapter contains information on the following subjects: → Indicator lamp → Information on changing bulbs → Removing and installing the headlights → Changing ...

Information on changing bulbs

First read and observe the introductory information and safety warnings ...

Other materials:

Contents
Fig. 162 Contents of the vehicle toolkit First read and observe the introductory information and safety warnings The content of the vehicle toolkit depends on the vehicle equipment level. The following describes the maximum scope. The vehicle toolkit contains the following Screwdriv ...

General Information
All components of the refrigerant circuit submitted for quality observation are always to be sealed (use original sealing caps of original part). To date, the original parts (compressor, reservoir, receiver/dryer, evaporator and co ...

Evaporator
Caution Non-approved tools or materials such as leak sealing additives can cause damage or malfunctions in the system. Only use tools and materials approved by the manufactu ...