Volkswagen Polo Service & Repair Manual: Test Requirements
 Note
| The A/C system is functioning correctly when the air flowing
from the instrument panel vents has a temperature of 70C
or lower. |
| Setting on Climatronic “LO”. |
| Setting on A/C system “AC” on; “max”; “cold”. |
| The A/C system OBD cannot find malfunctions with the Vehicle
Diagnostic Tester in “Guided Fault Finding”. The measured value
block does not show any shut-off condition for the A/C
compressor (only on vehicles with “A/C system” OBD). |
|
|
|
Note
The A/C system is functioning correctly when the air flowing
from the instrument panel vents has a temperature of 70C
or lower.
...
Other materials:
Diagonal Washouts
Diagonal wear spots on tires
Diagonal wear spots run at an angle of approximately 45°
with respect to the plane of circumference.
They usually occur once, but may also occur several times
along the tire circumference.
...
Overview of the driver door
Fig. 4 Overview of the controls in the
driver door (left-hand drive vehicles) The controls are mirrored in right-hand
drive vehicles
Key for :
Door release lever
Central locking button for locking and
unlocking the vehicle
Switch for adjusting the exterior mirrors:
...
Refrigerant Circuit with Restrictor and Reservoir
Arrows point in direction of refrigerant flow.
A-Low pressure side of refrigerant circuit.
B-High pressure side of refrigerant circuit.
Component
Aggregate state of refrigerant
...
© 2016-2026 Copyright www.vwpolo.net
Possible Concerns