Volkswagen Polo Service & Repair Manual: Switches and Sensors on Refrigerant Circuit and Connections
- A/C Refrigerant High Pressure Switch -F23
- Magnetic Clutch High Pressure Switch -F118
- A/C Refrigerant Low Pressure Switch -F73
- Refrigerant Circuit Connections with Valve for Switches
- A/C Pressure Switch -F129
- High Pressure Sensor -G65
- A/C Pressure/Temperature Sensor -G395
- A/C Compressor Regulator Valve -N280
Evacuating and Charging Valve, Low Pressure Side
Special tools and workshop equipment
required
Torque Wrench 1783 - 2-10Nm -VAG1783- with Torque Wrench
1783 - 1/4" Drive Ratchet -VA ...
A/C Refrigerant High Pressure Switch -F23
Note
For switching pressures, removing and installing switches
and switch arrangement and version, see vehicle-specific
refrigerant circuit.
...
Other materials:
CAN Bus Wires, Repairing
Unshielded two-strand wiring -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
can be used as CAN bus wiring.
The color coding of CAN bus wires can be found in the
following table:
...
Front airbags
Fig. 56 Location and deployment zone of
the driver front airbag
Fig. 57 Location and deployment zone of
the front passenger front airbag
First read and observe the introductory information
and safety warnings
In conjunction with the seat belts, the front airbag system gives the front occu ...
Locking the front passenger door and rear doors manually
Fig. 156 In the end face of the
right-hand door: manual lock covered by a rubber seal
Fig. 157 Manually locking the
vehicle with the vehicle key
First read and observe the introductory
information and safety warnings
If the vehicle has a lock cylinder in the door handle of the front passe ...
