Volkswagen Polo Owners Manual: Recycling and scrapping end-of-life vehicles
First read and observe the introductory information
and safety warnings
Recycling end-of-life vehicles
Volkswagen has already made provision for you to recycle your vehicle in an environmentally responsible manner. The recycling system operating in many European countries will take back your vehicle at the end of its useful life. Once the vehicle has been recycled, a certificate of destruction will be issued to show that the vehicle has been disposed of correctly.
End-of-life vehicles are recycled free of charge, provided that national legislation is complied with.
Further information on the recycling of end-of-life vehicles can be found at a Volkswagen dealership.
Scrapping
The relevant safety requirements must be observed when the vehicle or components of the airbag and the belt tensioners are scrapped. Qualified workshops are familiar with these requirements.
Declaration of conformity for wheels and tyres
First read and observe the introductory information
and safety warningsTyres fitted in the vehicle meet the requirement of BIS
and comply with the requirements under the Central Motor Vehicle Rule ...
Other materials:
Warning lamp and coolant temperature display
Fig. 138 Coolant temperature display in
instrument cluster: Ⓐ cold; Ⓑ normal; Ⓒ warning
First read and observe the introductory information
and safety warningsA display for the coolant temperature may be, depending
on the vehicle equipment, located in instrument cluster. In normal driv ...
Fuses in the vehicle
Fig. 172 Dash panel on the driver
side: fuse box cover
Fig. 173 In the front left of the
engine compartment: fuse box cover
First read and observe the introductory
information and safety warnings
Fuses must always be replaced by a new fuse with the same amp rating (same
colour and marki ...
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...
