Volkswagen Polo Service & Repair Manual: One-Part Test Paint

Volkswagen Polo Service & Repair Manual / General Paint Information / Original Products / SprayMax System / One-Part Test Paint

Definition:

One-Part Test Paint -LLS MAX 005-, black

Edition 10/2008

Product Description

The One-Part Test Paint -LLS MAX 005- is a single-compound product from the NC resin combinations.

Properties:

Easy application (one-part material)

Dries quickly

High yield

High covering capacity

Even application

Easy to sand

Application Instructions

Application

Detecting uneven surfaces in primer- and filler base surfaces

Base Surface

Suitable base surfaces:

All primers unsanded

All applied fillers unsanded

Pre-treatment of base surfaces:

–	Carefully clean using the Silicone Remover -LLS MAX 007- or Silicone Remover, Long -LLS MAX 0008-.

One-Part Test Paint

Processing

For work safety, wear appropriate, personal protective equipment.

Latex or nitrile protective gloves, for example

Breathing mask, for example type A2/P2

Application:

–	Thoroughly shake the can for at least two minutes and perform a short “spray test”.

One-Part Test Paint

Application type “coat”

–	Apply one misty, thin and even spray application.

–	The recommended dry layer thickness is 15 µm.

Spraying distance:

–	Maintain a distance of 20 to 25 cm.

Note

If the spraying procedure is interrupted, make sure that the valve above the spray head is empty to prevent any nozzle blockage.

One-Part Test Paint

Drying

Dry at +20 °C (68 °F) room temperature for 10 minutes. IR drying is possible with this product.

Caution

For work safety, wear appropriate, personal protective equipment.

Note the safety data sheets as well as the warnings on the label of the spray nozzle.

Shake briefly again before every subsequent spray application.

Dispose of the empty spray cans as recyclable material.

Characteristics

One-Part Test Paint

Solid matter content	approximately 16 %
Yield	Approximately 0.5 m² / spray can with 30 to 40 μm dry layer thickness
Note	Used only by a professional
VOC value	The EU limit for this product (product category IIB.b) in ready-to-use form is a maximum of 650 to 693 g/L volatile organic compounds. The VOC value of this product in ready-to-use form is a maximum of 260 to 277 g/can.

Storage

The guaranteed shelf life of 60 months from date of manufacture. Use no later than the date indicated on the label and store in original container at +20 °C (68 °F).

One-Part Test Paint

One-Part Anti-Corrosion Primer

Definition: One-Part Anti-Corrosion Primer -LLS MAX 003 M2-, reddish brown Edition 03/2013 Produc ...

One-Part Clear Coat

Definition: One-Part Clear Coat -LLS MAX 010- Edition 10/2008 Product Description ...

Other materials:

Ashtray in the drink holder
First read and observe the introductory information and safety warnings Fig. 104 Removable ashtray To use, place the removable ashtray in one of the drink holders in the front centre console or in the rear centre console . Opening and closing the ashtray To open, lift the ashtray cove ...

Repairs and faults in the airbag system
First read and observe the introductory information and safety warningsRepairs and modifications must always be carried out according to Volkswagen specifications . Modifications and repairs to the front bumper, the doors, the front seats, the roof, or the bodywork should be carried out by a ...

Odor from Evaporator or Heat Exchanger?
Fishy smell – From leak at cooling system of engine or of A/C system heater core. Note If the fishy smell gets weaker when the temperature is set to “cold” and stronger when i ...