|
Hoses, Repairing
Smooth Tube, RepairingDiagonal Washouts
Diagonal wear spots on tires
Diagonal wear spots run at an angle of approximately 45°
with respect to the plane of circumference.
They usually occur once, but may also occur several times
along the tire circumference.
...
Positive and earth jump lead connection points
Fig. 190 In the engine
compartment: jump lead connection point, positive ⊕
First read and observe the introductory
information and safety warnings
The positive jump lead connection point is in the engine compartment. In
order to establish a suitable earth connection, screw towing eye into ...
Taper
Taper is caused by slightly offsetting the tread and/or the
belt by a few tenths of a millimeter from the geometric center
of the tire. Taper cannot be recognized visually nor can it be
measured with workshop equipment.
...