Hub Cap for Alloy Wheels with Open Threaded Connection, Removing and
Installing
Decorative Trims, Replacing, Bonded Decorative TrimsIgnition lock
Fig. 107 Positions of the vehicle key in
the ignition lock
First read and observe the introductory information
and safety warnings The steering lock can be activated when
there is no vehicle key in the ignition lock.
Vehicle key positions
Ignition switched off. The vehicle key ca ...
Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Introduction
This chapter contains information on the following subjects:
→ Ignition lock
→ Starting the engine
→ Stopping the engine
→ Electronic immobilizer
Notes in this chapter concerning the automatic gearbox are applicable
both for the automatic gearbo ...