|
|
|
Wheel, Mounting, Audi Assembly Instructions
Tire InformationWheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Tread depth and wear indicators
Fig. 147 Tyre tread: wear indicators
First read and observe the introductory information
and safety warningsTread depth
Difficult driving situations demand the deepest possible tread depth for the
tyres and the same tread depth for the tyres on the front and rear axles. This applies
in pa ...
Warning lamp
First read and observe the introductory information
and safety warnings
Lit up
Possible cause
Solution
Fault in the alternator.
Go to a qualified workshop. The electrical system should
be checked.
Switch off all electrical ...