Volkswagen Polo Service & Repair Manual: Valve, Removing and Installing, Rubber Valve
| Make sure wheel rim is clean. |
|
|
|
| – |
Using the Valve Fitting Tool Valve Fitting Tool -VAS6459--1-,
insert a new tire valve. |
| – |
Remove the valve insert. |
| – |
Inflate tire to approximately 3 to 4 bar (43.5 to 58 psi),
tire bead must slip audibly over rim hump when doing this. |
| – |
Install the valve insert. |
| – |
Check the tire pressure for specified pressure. |
|
|
|
1. Valve Body
1 -
Valve body
2 -
Valve Insert
3 -
Valve cap
...
Special tools and workshop equipment
required
Torque Wrench -VAG1410-
Perform the Following:
Remo ...
Other materials:
Adjusting the steering wheel position
Fig. 41 Adjusting the steering wheel position
mechanically
First read and observe the introductory information
and safety warnings
Adjust the steering wheel position before setting off and only when the vehicle
is stationary.
Push down the lever .
Adjust the steering wheel so th ...
Drink holders in the centre console
Fig. 102 In the front centre console:
drink holders
Fig. 103 Drink holder in the rear centre
console: folding out the drink holder
First read and observe the introductory information
and safety warnings
Opening and closing the rear drink holder
To open, fold the drink holder down in the ...
Commercially Available Tools and Materials
Note
This list outlines the testers, tools and materials required
for expert refrigerant circuit repair work.
Caution
Non-approved tools or materials such as leak sealing
additiv ...
© 2016-2026 Copyright www.vwpolo.net
Valve, Removing and Installing, Valve Explanations
Valve, Removing and Installing, Metal Valve