Loading the load carrier system
IntroductionTire Wear, Center
This wear pattern is found on drive wheels on high-powered
vehicles that often drive long stretches at high speed.
At high speeds, the centrifugal force increases the tire
diameter at the center of the tread more than at the shoulders
of ...
Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator
Valve -N280-, Externally Regulated A/C Compressor
Specified Values
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „P ...