Volkswagen Polo Service & Repair Manual: Run-Flat System PAX, Dimensions and Designations on PAX Rims

Volkswagen Polo Service & Repair Manual / Whels, Tires, Whel Alignment / Rim Information / Run-Flat System PAX / Run-Flat System PAX, Dimensions and Designations on PAX Rims

Example: 235 x 500 A - 5 - 41

235 -

Designated width in millimeters

x -

One-part

500 -

Designated diameter of standardized rim seat in millimeters

A -	Asymmetrical

5 -	Number of bolt holes

41 -	Offset in millimeters

Run-Flat System PAX, Dimensions and Designations on PAX Rims

Run-Flat System PAX, Support Ring

Dimensions Overview of the most important dimensions: Names Example: ...

Run-Flat System PAX, Examining Support Ring

As with the tire, the supporting ring is generally not replaced after driving with flat tire. Replace the sup ...

Other materials:

Dimensions
Fig. 17 Dimensions First read and observe the introductory information and safety warnings The data in the table apply to the most basic German model. The specified values can vary due to different tyre and wheel sizes, if additional equipment is fitted, for different model versions, for ret ...

Wheel, Balancing with Fine Balancing Machine (Finish Balancer)
Before beginning balancing, the following requirements must be fulfilled. The tire pressure must be OK. The tire profile must not be worn on one side. The tire profile must be at least 4 mm. ...

Refrigerant Still in Circuit
Discharge the refrigerant circuit. – Remove malfunctioning component, flush with compressed air, collect escaping refrigerant oil. – The new component is to be filled with the amount of refrig ...