Volkswagen Polo Service & Repair Manual: Pressures, Checking
- Refrigerant Circuit Pressures (with A/C Service Station), Checking
- Checking with Restrictor and Reservoir, with Internally Regulated A/C Compressor
- Checking with Expansion Valve and Receiver/Dryer, with Internally Regulated A/C Compressor
- Checking with Expansion Valve and Receiver/Dryer, without Regulated A/C Compressor
- Checking with Restrictor, Reservoir and A/C Compressor Regulator Valve -N280-, Externally Regulated A/C Compressor
- Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator Valve -N280-, Externally Regulated A/C Compressor
Connecting Service Station
Turn off the ignition.
–
Connect the A/C service station to the power supply.
–
Connect qui ...
Other materials:
Headlamp Washer System
The following hose connection types are used for connecting
hoses to pumps and spray nozzles or as separating points
–
Disconnect by depressing clip
-1--arrow- and then separating coupling ...
Wheel, Balancing, Tire and Wheel Radial and Lateral Run-Out, Checking
Before beginning balancing, the following requirements must
be fulfilled.
The tire pressure must be OK.
The tire profile must not be worn on one side. The tire
profile must be at least 4 mm.
...
Cigarette Lighter Illumination Bulb -L28-, Removing and Installing
Note
On some vehicle equipment levels, socket illumination is via
Light Emitting Diode (LED) instead of a bulb. These LEDs are
integrated with the illumination housing and cannot be serviced
or replaced separately.
...
