Volkswagen Polo Service & Repair Manual: Battery Charger -VAS5903- Maintenance Charging

Volkswagen Polo Service & Repair Manual / Battery, Starter, Generator, Cruise Control / Battery, Charging / Battery Charger -VAS5903 / Battery Charger -VAS5903- Maintenance Charging

Note

If the battery is discharged by an electrical consumer during maintenance charging, the Battery Charger -VAS5903- automatically supplies the appropriate charge.

Maintenance charging can be performed without time restrictions.

The battery can be used constantly.

Observe the maintenance notes of the battery manufacturer.

WARNING

Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter „Warnings and Safety Precautions“.

WARNING

Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

If the battery is fully charged, the Battery Charger -VAS5903- starts maintenance charging.

–	Proceed as when charging the battery. Refer to → Chapter „Battery, Charging with Battery Charger -VAS5903-“.

With a charge status of 100%, all bars are indicated on the display.

Battery Charger -VAS5903- Maintenance Charging

Support Mode with Battery Charger -VAS5903

General Information The support mode provides the vehicle electrical system with voltage when the battery is removed or disconnected. ...

Battery Charger -VAS5906

...

Other materials:

Rain/light sensor
Fig. 75 Windscreen wiper lever: setting the rain/light sensor Ⓐ Fig. 76 Sensitive surface of the rain/light sensor First read and observe the introductory information and safety warnings When the rain/light sensor is activated, it automatically controls the frequency of the wiper inte ...

Checking with Expansion Valve, Receiver/Dryer and A/C Compressor Regulator Valve -N280-, Externally Regulated A/C Compressor
Specified Values Note Connecting service station. Refer to → Chapter „Connecting Service Station“. Observe test requirements. Refer to → Chapter „P ...

Special Connector Systems
Note If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to → Chapter „Secondary Lock“. ...