VW Polo manuals

Volkswagen Polo Service & Repair Manual: Connecting Service Station

  Turn off the ignition.
–  Connect the A/C service station to the power supply.
–  Connect quick-release coupling adapter to charging hoses of service station (handwheels not screwed in/hand shut-off valve not open).
–  Switch on service station and evacuate charging hoses (only necessary if there is air in charging hoses).
–  Switch off A/C service station.
–  Remove caps from service connections (with valve).
–  Connect the A/C service station to the refrigerant circuit using service connections with quick-release coupling adapters.
–  Screw in handwheel of quick-release coupling adapters only until valves are definitely open at refrigerant circuit connection (observe pressure gauge, do not strain valves).
–  Perform planned tests and measurements.
Ultrasound A/C Cleaner -VAS6189B
The Ultrasonic HVAC Cleaning System -VAS6189A- is placed in the front passenger footwell and sprays Aero-Clean. Aero-Clean neutralizes microbes and bacteria inside th ...

Pressures, Checking
...

Other materials:

Warning and indicator lamps
First read and observe the introductory information and safety warnings  Lit up Possible cause   Solution Handbrake is applied. Release the handbrake   . Brake system fault. Do not drive on! Obtain profe ...

Single Wire Seals, Installing
  Note Single wire seals prevent the penetration of water and dirt into the contact housing. They are installed, for example, in the engine compartment and must be reinstalled after a repair. Single wire seal is crimpe ...

Fuses in the vehicle
Fig. 172 Dash panel on the driver side: fuse box cover Fig. 173 In the front left of the engine compartment: fuse box cover First read and observe the introductory information and safety warnings Fuses must always be replaced by a new fuse with the same amp rating (same colour and marki ...

© 2016-2026 Copyright www.vwpolo.net