Volkswagen Polo Service & Repair Manual: Ultrasound A/C Cleaner -VAS6189B
| The Ultrasonic HVAC Cleaning System -VAS6189A- is placed in
the front passenger footwell and sprays Aero-Clean. Aero-Clean
neutralizes microbes and bacteria inside the heater and A/C
unit. |
| The unit comes with Operating Instructions. |
|
Evaporator, Cleaning with Suction Feed Spray Gun -VAG1538- and Spray
Nozzle
| Spray off the evaporator directly with Contra Sept using a
spray nozzle (approximately 10 bar (145 psi)). Contra Sept
neutralizes microbes and bacteria directly on the evaporator. |
| To make it possible to access the evaporator, some prework
and different spray nozzles are needed, for example
VAG1538/5;VAG1538/6 orVAG1538/7. |
| A vehicle-specific instruction booklet is included with the
evaporator cleaning solution D 600 100 A2 |
|
Fishy smell
–
From leak at cooling system of engine or of A/C system
heater core.
Note
...
Turn off the ignition.
–
Connect the A/C service station to the power supply.
–
Connect qui ...
Other materials:
Round Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
Locking the front passenger door and rear doors manually
Fig. 156 In the end face of the
right-hand door: manual lock covered by a rubber seal
Fig. 157 Manually locking the
vehicle with the vehicle key
First read and observe the introductory
information and safety warnings
If the vehicle has a lock cylinder in the door handle of the front passe ...
Welding and Soldering on Refrigeration Systems
Before performing welding or soldering work on vehicles near
the air conditioning system components, extract the refrigerant
and remove the residue by flushing with compressed air and
nitrogen.
The products of refrigerant decomposition d ...
© 2016-2026 Copyright www.vwpolo.net
Odor from Evaporator or Heat Exchanger?
Connecting Service Station