| There are several specifications located on the rim. The following examples shows the rim identification: |
| Replacement parts number: | 6E0 601 027 A |
| Size of disc wheel: | 6 J x 15 6 - Rim width in inches J - Shape of rim flange 15 - Rim diameter in inches |
| Offset (mm): | 43 |
| Indication for hump on bead seat: | EH2 Extended Hump 1) |
| 1) Raised round hump on both bead seats. These ensure that when using a tire with emergency mode properties in airless condition, the tire does not slip from the bead seat. Wheels with EH2 are only necessary if tires with emergency mode properties are mounted. Refer to → Chapter „Run-Flat Tire, General Information“.! |
Overview - Rim
Composite WheelsIntroduction
This chapter contains information on the following subjects:
→ Fuses in the vehicle
→ Changing a blown fuse
At the time of print we are unable to provide an up-to-date overview of the
locations of the fuses for the electrical consumers. This is because the vehicle
is under co ...
Checking with Expansion Valve and Receiver/Dryer, with Internally Regulated
A/C Compressor
Note
Connecting service station. Refer to
→ Chapter „Connecting Service Station“.
Observe test requirements. Refer to
→ Chapter „Pressures, Checking“.
–
...
Two-Part VHS Hardener and Two-Part VHS Performance Hardener
Definition:
Two-Part VHS Hardener -LHA 009 051 A2-/-LVM 009 051 A5-
Two-Part VHS Hardener, Short -LHA 009 050 A2-
Two-Part VHS Hardener, Long -LHA 009 052 A2-/-LHA 009 052
A3-
...