Volkswagen Polo Service & Repair Manual: Battery Charger -VAS5095A- Maintenance Charging

Volkswagen Polo Service & Repair Manual / Battery, Starter, Generator, Cruise Control / Battery, Charging / Battery Charger -VAS5095A / Battery Charger -VAS5095A- Maintenance Charging

WARNING

Risk of injury. Follow all Warnings and Safety Precautions. Refer to → Chapter „Warnings and Safety Precautions“.

WARNING

Batteries that have a light yellow visual indicator do not have to be tested or charged. Jump starting must not be used!

There is a risk of explosion during testing, charging or jump starting.

These batteries must be replaced.

During maintenance charging, the Battery Charger -VAS5095A- provides safe charging and preserves the charge of the battery.

–	Proceed as when charging the battery. Refer to → Chapter „Battery, Charging with Battery Charger -VAS5095A-“.

Note

If the battery is discharged by an electrical consumer during maintenance charging, the Battery Charger -VAS5095A- automatically supplies the appropriate charge.

Maintenance charging can be performed without time restrictions.

The battery can be used constantly.

Support Mode with Battery Charger -VAS5095A

General Information The support mode provides the vehicle electrical system with voltage when the battery is removed or disconnected. ...

Battery Charger -VAS5900

...

Other materials:

Refrigerant Circuit, Tracing Leaks, with Leak Detection System -VAS6196- or Leak Detection Kit -VAS6201A- or Succeeding Model
Note This repair manual describes different methods for detecting leaks in the refrigerant circuit. These methods have been tested and result in success when used correctly. If when searching for compressed air / Nit ...

Run-Flat System PAX, Examining Support Ring
As with the tire, the supporting ring is generally not replaced after driving with flat tire. Replace the support ring if the following damages have occurred: Blowouts or mis ...

Flat Connector Systems
Note If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to → Chapter „Secondary Lock“. ...