VW Polo manuals

Volkswagen Polo Service & Repair Manual: A/C Programmer -J127

This programmer switches the refrigerant flow direction through the second evaporator if the temperature on the cooling fins on the second evaporator lowers to the freezing point for water (icing protection).
 

A/C Programmer -J127

Electrical Components Not on Refrigerant Circuit
...

Coolant Fan Control Module -J293
  Note There are different construction styles.     This control module switches on and off the A/C clutch ...

Other materials:

Introduction
This chapter contains information on the following subjects:  → Positive and earth jump lead connection points  → How to start the engine using jump leads If the engine fails to start because the vehicle battery is flat, the flat battery can be connected to the battery of anothe ...

Autogas
Fig. 133 In the upper section of the centre console: switch for Autogas First read and observe the introductory information and safety warnings When the vehicle is restarted, the last manually selected operating mode will be adopted automatically. If, for example, autogas mode was activa ...

Tires, Reinforced, Extra Load
Some time ago, the designation “Reinforced” was replaced with the designation “Extra Load” by some tire manufacturers. In countries outside Europe, this designation has been conventional for some time. There are no technical differences. ...

© 2016-2026 Copyright www.vwpolo.net