VW Polo manuals

Volkswagen Polo Service & Repair Manual: Coolant Fan Control Module -J293

  Note
There are different construction styles.
   
This control module switches on and off the A/C clutch and therefore the A/C compressor. It switches the coolant fan and calculates the pressure in the refrigerant circuit on vehicles with a High Pressure Sensor -G65- or A/C Pressure/Temperature Sensor -G395-.
 

Coolant Fan Control Module -J293

A/C Programmer -J127
This programmer switches the refrigerant flow direction through the second evaporator if the temperature on the cooling fins on the second evaporator lowers to the fr ...

Coolant Fan Control Module -J293
  Note Available in different construction styles, some installed on coolant fan -arrows-.     This ...

Other materials:

Wire Break with Dual Repair Point
Repair point with intermediate wire section –  Free up wire intended for repair at two points (approximately 20 cm to both sides of respective repair points). –  If required, remove wiring harness wra ...

Refuelling autogas
Fig. 132 In the right-hand side of the vehicle at the rear: open tank flap with tank cap for gas filler neck ① and adapter ② First read and observe the introductory information and safety warnings Switch off the engine, ignition and mobile telephone before refuelling  . Please re ...

Technical Requirements
Factory-Installed Trailer Hitch If the vehicle was already delivered from the factory with a trailer hitch, all of the technical and legal requirements for towing a trailer have already been taken into account. Note that a »13-pin« trailer ...

© 2016-2025 Copyright www.vwpolo.net