Volkswagen Polo Service & Repair Manual: Special Tools

Volkswagen Polo Service & Repair Manual / Whels, Tires, Whel Alignment / Special Tools

Special tools and workshop equipment required

Wheel Bolt Master Socket Set -T10101-

Wheel Bolt Master Socket Set -T10101A-

Special tools and workshop equipment required

Wheel Bolt Master Socket Set -T40004-

Special tools and workshop equipment required

Wheel Bolt Master Socket Set -T40073-

Special tools and workshop equipment required

Torque Wrench 1332 40-200Nm -VAG1332-

Special tools and workshop equipment required

Torque Wrench -VAG1410-

Special tools and workshop equipment required

Wiring Harness Repair Set - Hot Air Blower -VAS1978/14A-

Special tools and workshop equipment required

Cartridge Gun -VAG1628-

Special tools and workshop equipment required

Trim Removal Wedge -3409-

Torque Wrench 1331 5-50Nm -VAG1331-

Wheel Bolt Master Socket Set -T10101-

Wax Spray -D 322 000 A2-

Optimol AT Paste -G 052 109 A2-

Edition 00053148821 C 02/04/2015 - ESP

Special tools and workshop equipment required

Emergency Wheels

Spare Wheel Notes If Necessary, Explain to the Customer the Information About Tires and Refer the Customer to the Owner's Manual. ...

Battery, Starter, Generator, Cruise Control

...

Other materials:

Contents
Fig. 162 Contents of the vehicle toolkit First read and observe the introductory information and safety warnings The content of the vehicle toolkit depends on the vehicle equipment level. The following describes the maximum scope. The vehicle toolkit contains the following Screwdriv ...

Indicator lamps
First read and observe the introductory information and safety warnings Lit up Possible cause Solution The start/stop system is not available. Automatic engine switch-off is active. Take your foot off the brake to start the ...

Warning and indicator lamp
First read and observe the introductory information and safety warnings Lit up Possible cause Solution Dual clutch gearbox DSG® overheated. Do not drive on! Move the selector lever to position P and leave the gearbox ...