Volkswagen Polo Owners Manual: Settings menu
First read and observe the introductory
information and safety warnings
| Settings menu | Function |
|---|---|
| Language | Setting the language for the display texts and messages in the navigation system. |
| MFD data | Settings for which MFD data should appear in the instrument cluster display . |
| Time | Setting the hours and minutes for the clock in the instrument cluster and in the navigation system. The time can be shown in a 12 and 24 hour display. An S may be shown in the upper part of the display to indicate that summer time is selected. |
| Winter tyres | Setting the visual and acoustic speed warning. Use this function only when winter tyres are fitted which are not designed for the vehicle's top speed. |
| Units | Setting the units for temperature, consumption values and distances. |
| Alt. speed dis. | Switching the second speed display on or off. |
| Travel mode | Adjusting the headlights in countries in which the traffic drives on the other side of the road. A tick is visible when the headlights on a left-hand drive vehicle are switched for driving on the left. The travel mode may only be used for a short period. |
| Service | Call up service messages. |
| Factory setting | Some functions in the Setup menu are reset to the factory settings. |
| Back | The display returns to the main menu. |
MFD (multifunction display) menu
First read and observe the introductory
information and safety warnings
The multifunction display (MFD) is equipped with two automatic memories:
1 - Trip memory and 2 - Total journey memory.
The ...
Other materials:
Changing bulbs in the side turn signals
Fig. 188 Removing the side turn
signal bulb
Fig. 189 Side turn signal:
changing the bulb
First read and observe the introductory
information and safety warnings
Depending on the vehicle, the side turn signal may be located in the front
wing or in the exterior mirror .
Please contact a ...
CAN Bus Wires, Repairing
Unshielded two-strand wiring -1-
and -2- with a cross section of
0.35 mm2 or 0.5 mm2
can be used as CAN bus wiring.
The color coding of CAN bus wires can be found in the
following table:
...
Flat Connector Systems
Note
If necessary, housing securing mechanisms (secondary locks)
must be released or removed using specified tool before
releasing the contacts. Refer to
→ Chapter „Secondary Lock“.
...
