Volkswagen Polo Service & Repair Manual: Safety Precautions
Safety Precautions when Painting Vehicles with Electric Drive
Caution
| Risk of damaging the battery cells at too high of
drying temperatures! |
| Observe the maximum drying time of 30 minutes at a
drying temperature of +80 °C (176 °F). |
| Observe the maximum drying time of 45 minutes at a
drying temperature of +60 °C (140 °F). |
| Protect all high-voltage components from direct
infrared radiation when IR drying. |
|
| Observe the Safety Precautions when Working on the Electric
Drive: |
| The above named drying information applies only to the Golf
MY 2009 blue-e-motion. For this vehicle the high-voltage battery
must be removed before heated drying. |
|
|
|
Other materials:
Single Wire Seals, Installing
Note
Single wire seals prevent the penetration of water and dirt
into the contact housing. They are installed, for example, in
the engine compartment and must be reinstalled after a repair.
Single wire seal is crimpe ...
Corrosion Protection for Body, Attached and Welded Parts
Attachments
Coat the insides of the fenders, doors, covers and lids
completely. A spray application wet in wet procedure is
sufficient.
Before assembly, the seal the inside of the attachments with
cavit ...
Underseal
First read and observe the introductory information
and safety warningsThe underside of the vehicle is coated to protect it from
corrosion and damage. The protective coating on the underside of the vehicle could
be damaged when driving. Volkswagen therefore recommends that the protective coati ...
© 2016-2025 Copyright www.vwpolo.net
